6
FORK, TRIPLE CLAMP
–
Mount dust boot
200655-11
–
Grease the O-ring of valve
Lubricant (T158) (
–
Mount valve
–
Mount valve
The adjusting tube protrudes 5 mm from the cartridge and can be pressed in
against the resistance of the spring.
The adjusting tube protrudes more than 7 mm from the cartridge and cannot
be pressed in against the resistance of the spring.
200674-10
–
Screw on fluid barrier
Info
The fluid barrier must be tightened as much as possible. Do not use tools.
–
Install the special tool on the cartridge.
Gripping tool (T14026S1) (
Info
The special tool must be used to prevent the adjusting tube from being
lifted and thus to prevent oil from reaching the piston rod.
200675-10
–
Push the cartridge with the spring seat and preload spacer into the inner tube.
–
Mount screw
Guideline
Cartridge screw
200683-10
–
Grease and mount screws
Lubricant (T152) (
200682-10
.
8
of the rebound damping.
9
p. 208)
of the rebound damping with the spring on adjusting tube
9
of the rebound damping from below in cartridge
9
as far as it will go.
B
p. 220)
of the cartridge with the seal ring and tighten it.
bm
of the axle clamp but do not tighten.
bn
p. 209)
.
bl
M12x1
25 Nm
(18.4 lbf ft)
25
.
bk