Using Headphones; Displaying Source Information - Integra DTR 5.9 Instruction Manual

Common Functions—Continued
7

Using Headphones

For private listening, you can connect a pair of stereo
headphones (1/4-inch phone plug) to the AV receiver's
Phones jack.
Notes:
• Always turn down the volume before connecting your
headphones.
• While the headphones plug is inserted in the PHONES
jack, the speakers are turned off. (The Powered Zone 2
speakers are not turned off.)
• When you connect a pair of headphones, the listening
mode is set to Stereo, unless it was already set to
Mono, Stereo, or Direct, in which case it stays the
same.
• When the multichannel DVD input is selected, only
the front left and front right channels can be heard in
the headphones.
50
Downloaded from www.Manualslib.com manuals search engine

Displaying Source Information

You can display various information about the current
input source as follows.
Press the [Receiver] Remote
Mode button, and then press the
[Display] button repeatedly to
cycle through the available infor-
mation.
Note:
• This procedure can also be performed on the AV
receiver by using its [Display] button.
The following information can typically be displayed:
Input source &
1
volume*
2
Signal format*
or sampling
frequency
Input source &
listening mode
*1 When AM or FM radio is used, the band, preset num-
ber, and frequency are displayed.
*2 If the input signal is analog, or AM or FM radio is
selected, no format information is displayed. If the
input signal is PCM, the sampling frequency is dis-
played. If the input signal is digital but not PCM, the
signal format is displayed. Information is displayed
for about 3 seconds, then the previous display reap-
pears.