Other Connections; Am/Fm Antenna Connections; Network Connection; Headphones Connection - Integra DTR-50.6 Basic Manual

1/2"-5/8"(12-15 mm)
Cut and remove the plastic coating from the end of the
speaker cable, twist the core and connect it to the terminal.
Make correct connection between the unit's jacks and
speaker's jacks (+ to + and - to -) for each channel. If
connection is wrong, a bass sound may become poor
due to reverse phase. Attaching the supplied colored
speaker cable labels to the + side on the both ends of
each channel's cable will help correct connection. The
subwoofer jack supports connection of a subwoofer with
built-in power amplifier. Set the cut-off filter selection
switch of the subwoofer to DIRECT. If the subwoofer does
not have a cut-off filter selection switch but has a cut-off
frequency adjusting dial, turn it to the maximum frequency.
If your subwoofer does not have built-in power amplifier,
you can connect a power amplifier between the unit and the
subwoofer.
• The speaker setting is 7.1 ch at the time of purchase.
You can change it manually or by using automatic
speaker setting.
• Short-circuiting the + cable and - cable or contacting the
cable core to the rear panel of the unit may cause failure.
Also do not connect two or more cables to one speaker
terminal or one speaker to several terminals.
• Using a speaker with less impedance than the setting
may result in failure.
6
When using commercially available banana plugs:
tighten the speaker terminals to the end and then insert the
banana plugs. Do not insert the cable core directly into the
hole for banana plug of speaker terminal.
(North American model)
3

Other connections

AM/FM Antenna Connections

Connect the antennas to listen to AM/FM broadcast. When
listening to the broadcast for the first time, adjust the
antenna position and orientation to get the best reception.
AM loop antenna (supplied)
Indoor FM antenna
(supplied)
Fix with a tack on
the wall.
(North American model) (Other models)
Assemble the AM loop antenna (supplied).
Step 1: Connections

Network Connection

You can enjoy Internet radio and DLNA by connecting the
unit to LAN. Connect the Ethernet cable to the Ethernet
port of the router.
Internet radio
Router

Headphones Connection

Connect stereo headphones with a standard plug (1/4 inch
or ø 6.3 mm) to the PHONES jack on the front panel.
Sound from the speakers will be off while you are using the
headphones.
• If you selected any other listening mode than Stereo,
Mono and Direct, connecting headphones will switch the
listening mode to Stereo.
PC
NAS