Listening To Am/Fm Stations - Integra DTR 5.9 Instruction Manual

Listening to the Radio—Continued

Listening to AM/FM Stations

With the built-in tuner, you can enjoy AM and FM radio
stations and store your favorite stations as presets for
easy selection.
Tuning into AM/FM Radio Stations
■ Auto Tuning Mode
1
2
When tuned into a station, the TUNED indicator
appears. When tuned into a stereo FM station, the FM
STEREO indicator also appears.
Downloaded from www.Manualslib.com
Tuning Mode Tuning
Tuner
Use the [Tuner] input selector
button to select AM or FM.
In this example, FM has been selected.
Band Frequency
(Actual display depends on country.)
Press the [Tuning Mode] button
so that the AUTO indicator
appears on the display.
Press the Tuning Up or Down
[ ]/[ ] button.
Searching stops when a station is
found.
FM STEREO
AUTO
manuals search engine
■ Manual Tuning Mode
1
2
The North American model changes FM frequency in
0.2MHz steps, 10kHz steps for AM. For other models
it's 0.05MHz steps for FM and 9kHz (or 10kHz) steps
for AM.
In Manual Tuning mode, FM stations will be in mono.
Tuning into Weak FM Stereo Stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
Manual Tuning mode and listen to the station in mono.
Note:
• You can also use the remote controller's Up and Down
[ ]/[ ] buttons to tune the radio.
TUNED
Press the [Tuning Mode] button
so that the AUTO indicator disap-
pears from the display.
Press and hold the Tuning Up or
Down [ ]/[ ] button.
The frequency stops changing when
you release the button.
Press the button repeatedly to change
the frequency one step at a time.
53