IBM Aptiva Reference Manual page 65

Error code and description
662
Floppy Disk Controller
Error
662
Floppy Drive A Error
662
Onboard Floppy Drive
Conflict(s)
962
Onboard Parallel Port
Conflict(s)
Here's what to do...
Load the Setup default settings in Setup. For
information on using the Setup Utility, see "Using the
Setup Utility" on page 71.
1 Make sure that the Diskette Drive A parameter setting
is correct. For information on Setup Utility options,
see the Aptiva online help.
2 Make sure the diskette drive signal cable is properly
connected to the drive and to the system board.
3 Make sure the drive power cable is properly plugged
in.
4 If the error still shows after doing steps 1 to 3, replace
diskette drive A. It may be defective.
1 Remove all the add-on cards in the system.
2 Power on the system to see if it works without the
cards.
3 Re-install the cards one by one to determine which of
the cards caused the error.
4 After determining the defective card or cards, replace
the cards.
For instructions on installing add-on cards, see the
Aptiva online help.
Enter Setup and do any of the following:
• Change the onboard parallel port I/O address and IRQ
or disable it.
• Change the add-on card parallel port I/O address and
IRQ then reboot the system.
For information on the Setup Utility options, see the
Aptiva online help.
If any of these problems continue after taking the actions
listed, run the diagnostics programs that came with your
computer. If you need service, see "HelpWare support and
services" on page 79.
Responding to error codes
Troubleshooting
61