IBM Aptiva Reference Manual page 16

12
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult an IBM authorized dealer or service
representative for help.
Properly shielded and grounded cables and connectors
must be used in order to meet FCC emission limits.
Proper cables and connectors are available from IBM
authorized dealers. IBM is not responsible for any radio
or television interference caused by using other than
recommended cables and connectors or by
unauthorized changes or modifications to this
equipment. Unauthorized changes or modifications
could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
this device may not cause harmful interference, and (2)
Regulatory notices