Table of Contents
Advertisement
System Access configuration
Command: /cfg/sys/access
[System Access Menu]
mgmt
user
http
https
wport
snmp
tnet
tnport
cur
The following table describes the System Access Configuration menu options.
Table 74 System Access Configuration Menu options
Command
mgmt
user
http
disable|enable
https
wport <TCP port
number>
snmp disable|read-
only|read-write
tnet
tnport <TCP port
number>
cur
Management Networks configuration
Command: /cfg/sys/access/mgmt
[Management Networks Menu]
add
rem
cur
clear
The following table describes the Management Networks Configuration menu options. You can configure up to 10
management networks on the switch.
Table 75 Management Networks Configuration menu options
Command
add <IP address> <IP mask>
rem <IP address> <IP mask>
cur
clear
- Management Network Definition Menu
- User Access Control Menu (passwords)
- Enable/disable HTTP (Web) access
- HTTPS Web Access Menu
- Set HTTP (Web) server port number
- Set SNMP access control
- Enable/disable Telnet access
- Set Telnet server port number
- Display current system access configuration
Description
Displays the Management Configuration Menu.
Displays the User Access Control Menu.
Enables or disables HTTP (Web) access to the Browser-based Interface. It is enabled by
default.
Displays the HTTPS Menu.
Sets the switch port used for serving switch Web content. The default is HTTP port 80.
Disables or provides read-only/write-read SNMP access.
Enables or disables Telnet access to the switch. It is enabled by default.
Sets an optional telnet server port number for cases where the server listens for telnet
sessions on a non-standard port. The default is telnet port 23.
Displays the current system access parameters.
- Add mgmt network definition
- Remove mgmt network definition
- Display current mgmt network definitions
- Clear current mgmt network definitions
Description
Adds a defined network through which switch access is allowed
through Telnet, SNMP, or the browser-based interface. A range
of IP addresses is produced when used with a network mask
address. Specify an IP address and mask address in dotted-
decimal notation.
Removes a defined network, which consists of a management
network address and a management network mask address.
Displays the current management networks parameters.
Clear the current configured management networks.
Command Line Interface 75
Advertisement
Table of Contents
