Port configuration
Command:
/cfg/port <port number>
[Port 1 Menu]
speed
fctl
auto
name
ena
dis
cur
This menu enables you to configure settings for individual switch ports. This command is enabled by default.
NOTE: Port 19 is a port for switch management interface (interface 256). Cross-link ports (17-18) are not
available on the SmartPanel software.
The following table describes the Port Configuration Menu options.
Table 80 Port Configuration Menu options
Command
speed 10|100|1000|any
fctl rx|tx|both|none
auto on|off
name <1-64 characters>|none
ena
dis
cur
Spare Ports Group configuration
Command: /cfg/spgroup
[Spare Ports Group Menu]
addport
cur
Use these menu options to set unused ports to Spare Ports Group. Set the ports, which Port Group 1-5 do not
contain, to Spare Ports Group.
The following table describes the Spare Ports Group Configuration menu options.
Table 81 Spare Ports Group Configuration menu options
Command
add <port number>
cur
- Set link speed and force full duplex mode
- Set flow control
- Set auto negotiation
- Set port name
- Enable port
- Disable port
- Display current port configuration
Description
Sets the link speed. Not all options are valid on all ports. The choices
include:
•
10 Mb/s
•
100 Mb/s
•
1000 Mb/s
•
"any," for automatic detection (default)
Note: Ports 1-16 are set to 1000 Mb/s, and cannot be changed.
Sets the flow control. The choices include:
•
Receive (rx) flow control
•
Transmit (tx) flow control
•
Both receive and transmit flow control (default)
•
No flow control
Enables or disables auto-negotiation for the port. The default is
enabled.
Set the port name.
Enables the port.
Disables the port. To temporarily disable a port without changing its
configuration attributes, see the "Operation Menu" section.
Displays current port parameters.
- Add ports to the group
- Display current group configuration
Description
Adds the specified port to Spare Ports Group.
Displays the current Spare Ports Group configuration.
Command Line Interface 78