Table of Contents
Advertisement
RADIUS server configuration
Command: /cfg/sys/radius
[RADIUS Server Menu]
prisrv
secsrv
secret
secret2
port
retries
timeout
bckdoor
secbd
on
off
cur
NOTE: See the Application Guide for information on RADIUS.
The following table describes the RADIUS Server Configuration Menu options.
Table 61 RADIUS Server Configuration Menu options
Command
prisrv <IP address>
secsrv <IP address>
secret <1-32 characters>
secret2 <
1-32 characters
port <UDP port number>
retries <1-3>
timeout <1-10>
bckdoor enable|disable
secbd enable|disable
on
off
cur
IMPORTANT:
console or Telnet/SSH/HTTP/HTTPS. Backdoor for console is always enabled, so you can connect using
noradius and the administrator password even if the backdoor (bckdoor) or secure backdoor (secbd) are
disabled.
If backdoor is enabled (bckdoor ena), type in noradius as a backdoor to bypass RADIUS checking, and
use the administrator password to log into the switch. The switch allows this even if RADIUS servers are
available.
If secure backdoor is enabled (secbd ena), type in noradius as a backdoor to bypass RADIUS checking,
and use the administrator password to log into the switch. The switch allows this only if RADIUS servers are
not available.
- Set primary RADIUS server address
- Set secondary RADIUS server address
- Set primary RADIUS server secret
- Set secondary RADIUS server secret
- Set RADIUS port
- Set RADIUS server retries
- Set RADIUS server timeout
- Enable/disable RADIUS backdoor for telnet/ssh/http/https
- Enable/disable RADIUS secure backdoor for telnet/ssh/http/https
- Turn RADIUS authentication ON
- Turn RADIUS authentication OFF
- Display current RADIUS configuration
>
If RADIUS is enabled, you must login using RADIUS authentication when connecting via the
Description
Sets the primary RADIUS server address.
Sets the secondary RADIUS server address.
This is the shared secret between the switch and the RADIUS
server(s).
This is the secondary shared secret between the switch and the
RADIUS server(s).
Enter the number of the User Datagram Protocol (UDP) port to be
configured, between 1500-3000. The default is 1645.
Sets the number of failed authentication requests before switching to a
different RADIUS server. The range is 1-3 requests The default is 3
requests.
Sets the amount of time, in seconds, before a RADIUS server
authentication attempt is considered to have failed. The range is 1-10
seconds. The default is 3 seconds.
Enables or disables the RADIUS back door for telnet/SSH/
HTTP/HTTPS. The default value is disabled. This command does not
apply when secure backdoor (
secbd
Enables or disables the RADIUS back door using secure password for
telnet/SSH/ HTTP/HTTPS. The default value is disabled. This
command does not apply when backdoor (bckdoor) is enabled.
Enables the RADIUS server.
Disables the RADIUS server. This is the default.
Displays the current RADIUS server parameters.
) is enabled.
Command Line Interface 65
Advertisement
Table of Contents
