Table of Contents
Advertisement
Information Menu
Introduction
You can view configuration information for the switch in the user, operator, and administrator command modes.
This chapter discusses how to use the CLI to display switch information.
Menu overview
Command: /info
[Information Menu]
sys
l2
l3
link
port
group
dump
The following table describes the Information Menu options.
Table 15 Information Menu options
Command
sys
l2
l3
link
port
group
dump
- System Information Menu
- Layer 2 Information Menu
- Layer 3 Information Menu
- Show link status
- Show port information
- Show group information
- Dump all information
Usage
Displays system information.
Displays the Layer 2 Information Menu.
Displays the Layer 3 Information Menu.
Displays configuration information about each port, including:
•
Port number
•
Port speed (10 Mb/s, 100 Mb/s, 1000 Mb/s, or any)
•
Duplex mode (half, full, or any)
•
Flow control for transmit and receive (no, yes, or any)
•
Link status (up or down)
Displays port status information, including:
•
Port number
•
Port name
•
VLAN membership
Displays the group information
Dumps all switch information available from the Information Menu (10K or more, depending on
your configuration).
If you want to capture dump data to a file, set your communication software on your workstation
to capture session data prior to issuing the dump commands.
Command Line Interface 31
Advertisement
Table of Contents
