Table of Contents
Advertisement
System Access configuration
The following table describes the System Access Configuration commands.
Table 93 System Access Configuration commands
Command
[no] access http enable
access http port <TCP port
number>
[no] access snmp {read-
only|read-write}
[no] access telnet enable
access telnet port <TCP
port number>
access tftp-port <TFTP port
number>
show access
Management Networks configuration
The following table describes the Management Networks Configuration commands. You can configure up to 10
management networks on the switch.
Table 94 Management Networks Configuration commands
Command
access management-network <IP
address> <IP mask>
no access management-network <IP
address> <IP mask>
show access management-network
Description
Enables or disables HTTP (Web) access to the Browser-based Interface. It
is enabled by default.
Command mode: Global configuration
Sets the switch port used for serving switch Web content. The default is
HTTP port 80.
Command mode: Global configuration
Disables or provides read-only/write-read SNMP access.
Command mode: Global configuration
Enables or disables telnet server. It is enabled by default.
Command mode: Global configuration
Sets an optional telnet server port number for cases where the server listens
for telnet sessions on a non-standard port. The default is 23.
Command mode: Global configuration
Sets an optional telnet server port number for cases where the server listens
for TFTP sessions on a non-standard port. The default is 69.
Command mode: Global configuration
Displays the current system access parameters.
Command mode: All except User EXEC
Description
Adds a defined network through which switch access is allowed
through Telnet, SNMP, RIP, or the browser-based interface. A range
of IP addresses is produced when used with a network mask
address. Specify an IP address and mask address in dotted-decimal
notation.
Command mode: Global configuration
Removes a defined network, which consists of a management
network address and a management network mask address.
Command mode: Global configuration
Displays the current management networks parameters.
Command mode: All except User EXEC
N8406-023 1Gb Intelligent L3 Switch Command Reference Guide (ISCLI) 96
Advertisement
Table of Contents
