Test Print - Oki C5500 Maintenance Manual

5.3.2.5 Test print

This self-diagnosis is practiced to print test patterns built in PU. Other test patterns are stored in
the controller.
This print cannot be used to check the print quality.
To diagnose abnormal images, follow Section 7.
1. Activate the self-diagnostic mode (Level 1), press and hold down the MENU+ or MENU- key,
until "TEST PRINT" appears in the upper line of the display section, and then, press the ENTER
key. (The MENU+ key increments a test item, and the MENU- key decrements a test item.)
2. The lower line of the display section shows the set items that are applicable to the test print
only. Press and hold down the MENU+ or MENU- key, until the corresponding item appears,
and press the ENTER key. (The MENU+ key increments a test item, while the MENU- key
decrements a test item.)(If the set values of the items are not necessary (Default settings), go
on to Item 5.)
3. When the ENTER key is depressed after holding down the MENU+ or MENU- key in Item 2
above, a set item is displayed in the upper line of the display section, and a set value, in the
lower line. Pressing the MENU+ key increments the set value, and pressing the MENU- key
decrements it (the set value finally displayed will be applied). Pressing the BACK key defines
the value and restores Item 2. Repeat Item 3, as needed.
TEST PATTERN
1
Indication
PRINT EXECUTE
TEST PATTERN
CASSETTE
PAGE
COLOR
DUPLEX
(Indicated only when
Duplex is mounted)
MONO SPEED
COLOR SPEED
* --- denotes a default value. Items set here are valid only in this test mode
(Not written to the EEPROM).
43085101TH Rev.1
Set value
—
Pressing the ENTER key initiates print and pressing the CANCEL
key ends the print (Page by page).
0 0: Blank sheet print
1 - 7: See the following page (Pattern print).
8 - 15: Blank sheet print
TRAY1 Select the paper feed source.
TRAY2 If TRAY 2 is not mounted, indication of TRAY2 will not be
FF produced.
0000 Setup of the number of test-print pages
ON Select between Color print or Monochrome print.
OFF
* If ON is specified, ON/OFF needs to be specified for each color.
2 PAGES STACK Two-sided print is conducted with two-page stack.
OFF OFF is selected for two-sided print.
1PAGES STACK Two-sided print is conducted with one-page stack.
DEFAULT The monochrome print speed is set.
LOW LOW:28ppm
HIGH HIGH:32ppm
DEFAULT:24ppm
DEFAULT The color print speed is set.
LOW LOW:24ppm
HIGH HIGH:26ppm
DEFAULT: 20ppm
Oki Data CONFIDENTIAL
Function
125 /