Oki C5500 Maintenance Manual page 150

• To specify a PU Serial Number, enter a 11-digit number prefixed with "0" (single-byte
zero). (Notice that, when the PU Serial Number is read, it is a 10-digit number.)
On the "PU Serial Number setup" screen, enter the 11-digit number resulting from
prefixing a single-byte zero to the 10-digit number which is obtained by excluding the
two digits for Revision, shown in the image diagram below, from the serial number on
the "PU Serial Number setup" screen.
[Other than for OEL]
Enter the 11-digit number resulting from prefixing "0" (single-byte zero) to the 10-digit number.
[For OEL]
Enter the 11-digit number resulting from appending "0" (sing-byte zero) to the left of the 10 digits of Lot Number
• The PU Serial Number is not output in the Printer Serial Number field of the Menu Map
header section. The CU Serial No. is output in this field. Therefore, after the PU Serial
Number has been rewritten, check it by reading the PU Serial Number again from the
maintenance utility.
• In the case of the OEL destination, the PU Serial Number is output, as a Lot Number, in
the Lot Number field in the bottom line of the Menu Map header section after the
configuration at the UK Plant. [See 1. (2) of Subsection 5.4.2.]
• When the PU Serial Number is read, a 10-digit number will be read and displayed.
(2) Switching to Shipping mode
When the engine control PCB has been replaced with a new one, the printer still is in the
Factory Work mode. Switch it to the Shipping mode.
• Make the switching on the "Subsection 2.4.1.1.2.2 Factory/Shipping mode" screen in
"Subsection 2.4.1.1.2 PU PCB setup function" of the maintenance utility.
43085101TH Rev.1
A E 0 1 2 3 4 5 6 7 8 9
Figure of Serial No. label image
Ser.NO. 4AEL4011702K
Lot.NO. AE47027880 A0
Made in Thailand
Configured in UK
(Enter "0AE47027880.")
Figure of Serial No. label image (labeled in UK Factory)
(Enter "0AE1234567.")
A B Made in C
Revision
Oki Data CONFIDENTIAL
Revision
150 /