Producing A Test Print - Oki ML5721 User Manual

2. Switch off the outlet power (1a) and then unplug from the power outlet (1b).
1a
1b
3. Unplug the power cable connector (2) from the printer (3).
P
RODUCING A TEST PRINT
To check that your printer is operational, produce a test print on a sheet of 80 gsm A4 paper
(for example) as follows:
> Allow at least 5 seconds between turning the printer ON after
turning it OFF. A shorter time interval between turning ON/OFF
operations may cause printer power failure.
> Do not turn the printer OFF while it is printing as this may result
in damage to the print head.
1.
Turn the printer Power Switch to OFF.
NOTE
Ensure that the ribbon cartridge is properly installed before printing a Test
Page.
2.
Set the Paper Type Lever to cut sheet and set the Paper Thickness Lever to position
1.
3. Press and hold the SEL and LF/FF button and turn the Power Switch to ON. The SEL
LED will flash.
4. Press and hold down the LF/FF button and then press the LOAD/EJECT button again.
The alarm indicator should be illuminated to indicate that there is no paper in the
printer.
5.
With the long side of the paper against the paper guide, insert the paper carefully
into the printer. The printer will automatically grip the paper.
6. The printer will start the test print.
NOTE
If required, you can pause the test print by pressing the SEL button and then
resume the test print by again pressing the SEL button.
3
2
CAUTION!
Getting started > 13