Table of Contents
Advertisement
Spreadsheet View: PCB Layers Tab
Spreadsheet View: Parts Position Tab
© National Instruments Corporation
Column
Part Group
Double-click to display the Select Groups dialog
box, where you select the part group to which you
wish to assign the Keep-in/out. You can also set this in
Keep-in/Keep-out Properties dialog box. Refer to
the
Chapter 5,
information.
Heights
Assign a height (z-axis) value to theKeep-in/out. Can be
Bigger Than
entered directly, or in the Keep-in/Keep-out
Properties dialog box. Refer to the
Keep-in/Keep-out Areas
with Traces and
Use the PCB Layers tab to work with layer information.
Column
Layer Name
The name of the layer, for example, Copper Top.
Routable
Select Yes to allow trace routing on the layer; select
No to prevent trace routing on the layer.
Trace Bias
Set the trace bias by selecting Horizontal, Vertical or
None.
Type
The type of layer. Choices are Ground, Power,
Signal or Unassigned.
Use the Parts Position tab to view and export part position information.
Column
RefDes
The part's Reference Designator.
Position X
The part's position on the X axis.
Position Y
The part's position on the Y axis.
Side
The side of the PCB on which the part appears.
Rotation
The orientation of the part on the PCB.
Description
Working with Keep-in/Keep-out Areas
Working with Traces and
Copper, for more information.
Description
Description
1-45
Chapter 1
User Interface
section of
Copper, for more
Working with
section of Chapter 5,
Working
NI Ultiboard User Manual
Advertisement
Table of Contents
