Table of Contents
Advertisement
Design»Polygon Splitter
Design»Shape to Area
Design»Swap Pins
Design»Swap Gates
Design»Automatic Pin Gate Swap
Design»Part Shoving
Design»Set Reference Point
Design»Shield Nets
© National Instruments Corporation
Use to split a copper area or powerplane. Refer to the
section of Chapter 5,
Working with Traces and
information.
Use to cut out areas in a copper shape to avoid other elements within its
area. Refer to the
Converting a Copper Shape to an Area
Chapter 5,
Working with Traces and
Refer to the
Swapping Pins
Copper, for information.
Refer to the
Swapping Gates
and
Copper, for information.
Refer to the
Automatic Pin/Gate Swapping
with Traces and
Copper, for information.
Use to toggle shoving on and off. When shoving is on, parts shove any
others out of the way when being moved or placed. Refer to the
Parts
section of Chapter 4,
Use to define the reference point for your board. Refer to the
Board's Reference Point
more information.
Use to shields nets. Refer to the
Working with Traces and
Appendix A
Copper, for more information.
section of Chapter 5,
section of Chapter 5,
Working with
Parts, for more information.
section of Chapter 3,
Shielding Nets
Copper, for more information.
A-15
Menus and Commands
Splitting Copper
Copper, for more
section of
Working with Traces and
Working with Traces
section of Chapter 5,
Working
Shoving
Setting the
Setting Up a
Design, for
section of Chapter 5,
NI Ultiboard User Manual
Advertisement
Table of Contents
