Select Toolbar - National Instruments Graphical User Interface Ultiboard User Manual

Select Toolbar

© National Instruments Corporation
Button
Place Via button. Places a via on the design. Refer to the
Working with Vias
Traces and
Place Copper Area button. Places a copper area on the
design.
Create Power Plane button. Places a powerplane on the
design. Refer to the
Chapter 5,
information.
Design Rule Check button. Runs the Design Rule
Check and places results in the Results tab.
Place Text button. Places text on the design. Refer to the
Placing and Editing Text
for Manufacturing/Assembly, for more information.
Show 3D button. Displays the current design in three
dimensions. Refer to the section of Chapter 9,
Designs in
Help button. Displays the helpfile contents page.
The Select toolbar contains the functions used to control selection filters,
and appears by default when you run Ultiboard. Please note that all filters
are not available in all versions of Ultiboard. The Select toolbar buttons are
explained in the table below.
Button
Enable Selecting Parts button. Use to allow or prevent
selection of parts.
Enable Selecting Traces button. Use to allow or prevent
selection of traces.
Description
section of Chapter 5,
Copper, for more information.
Placing Powerplanes
Working with Traces and
section of Chapter 8,
3D, for more information.
Description
1-5
Chapter 1 User Interface
Working with
section of
Copper, for more
Preparing
Viewing
NI Ultiboard User Manual