Table of Contents
Advertisement
Viewing and Editing Through Hole Pin Properties
© National Instruments Corporation
Complete the following steps to add a vertex to any line segment of a
polygon:
1.
Select the line (a selected line segment will have filled selection boxes
while the other selection boxes in the polygon will be open).
2.
Select Edit»Vertex»Add Vertex. A vertex is added in the middle of
the segment.
You can now move that vertex to change the shape of the polygon.
Complete the following steps to remove a vertex:
1.
Click on the point to be removed.
2.
Choose Edit»Vertex»Remove Vertex. The vertex is removed, and the
vertices on either side are joined by a straight line.
Complete the following to change the size of a design's vertices:
1.
Edit the Minimum control point size field in the General tab of the
Preferences dialog box. Refer to the
Chapter 1,
User
Interface, for more information.
Complete the following steps to edit through hole pin properties:
1.
Select the desired through hole pin and select Edit»Properties.
2.
The Through Hole Pin Properties dialog box appears, consisiting of
five tabs: Attributes, General, Pad, Layer Settings and Thermal
Relief.
General Tab
4-31
Chapter 4
Working with Parts
section of
NI Ultiboard User Manual
Advertisement
Table of Contents
