Table of Contents
Advertisement
Edit»Find
Edit»Select All
Edit»Select Entire Trace
Edit»Group Selection
Edit»Ungroup Selection
Edit»Lock
Edit»Unlock
© National Instruments Corporation
•
Open Trace Ends—Use to delete all open trace ends in the design.
Use to clean up the design after design completion. Refer to the
Deleting Open Trace Ends
Manufacturing/Assembly, for more information.
•
Copper Island—Use to remove copper islands. Refer to the
Copper Areas
section of Chapter 5,
for more information.
Use to find an element in the design. Refer to the
Elements
section of Chapter 2,
Use to select everything on a board, no matter what layer the elements are
on. Refer to the
Searching for Design Elements
Beginning a
Design, for more information.
Use to select a whole trace when one or more segments of the same trace
are selected.
Groups selected elements together. Grouped elements can be moved
together.
Ungroups the individual elements in a group.
Locks the selected elements in place so they cannot be moved.
Unlocks the selected elements.
Appendix A
section of Chapter 8,
Working with Traces and
Beginning a
A-5
Menus and Commands
Preparing for
Searching for Design
Design, for more information.
section of Chapter 2,
NI Ultiboard User Manual
Placing
Copper,
Advertisement
Table of Contents
