HP ProCurve 9304M Installation And Configuration Manual page 99

USING THE CLI
To display the software in the device's flash areas, enter the following command at any CLI level:
MON-HP9300(config)# show flash
Active management module:
Code Flash Type: AMD 29F032B, Size: 64 * 65536 = 4194304, Unit: 4
Boot Flash Type: AMD 29F040, Size: 8 * 65536 = 524288
Compressed Pri Code size = 2852369, Version 07.6.042SPT23 (T-Flowr7604.bin)
Compressed Sec Code size = 2848200, Version 07.6.04T22
Maximum Code Image Size Supported: 7011840 (0x006afe00)
Boot Image size = 162664, Version 07.03.00 (m2b.bin)
Monitor Image Version 4, for DRAM size 268435456
2/1: Pri (1231492, 07.6.042SPT72), Sec (1004047, 07.2.11T71) Boot
(07.01.00)
2/2: Pri (1231492, 07.6.042SPT72), Sec (1004047, 07.2.11T71) Boot
(07.01.00)
2/3: Pri (1231492, 07.6.042SPT72), Sec (1004047, 07.2.11T71) Boot
(07.01.00)
Syntax: show flash
The lines highlighted in bold in this example list the software installed on the module:
• The Compressed Pri Code and Compressed Sec Code lines list the flash code installed in the flash areas on
the module.
• The Boot Image line lists the boot code.
• The T-Flow lines list the flash images and boot code installed on the TSPs. The numbers following "T-Flow"
indicate the chassis slot number that contains the T-Flow and the TSP number on the T-Flow.
Displaying General Module Information
To display general module information, use the following method.
Using the T-Flow Redundant Management Module
4 - 11