Determining The Boot Image Version Running On The Device; Determining The Image Versions Installed In Flash Memory; Image File Types - HP ProCurve 9304M Installation And Configuration Manual

Installation and Basic Configuration Guide
The version information is shown in bold type in this example.
• "07.5.04T53" indicates the flash code version number. The "T53" is used by HP for record keeping.
• "labeled as H2R07504" indicates the flash code image label. The label indicates the image type and version
and is especially useful if you change the image file name.
• "Primary H2R07500.bin" indicates the flash code image file name that was loaded.

Determining the Boot Image Version Running on the Device

To determine the boot image running on a device, enter the following command at any level of the CLI:
HP9300> show flash
Active management module:
Code Flash Type: AMD 29F032B, Size: 64 * 65536 = 4194304, Unit: 2
Boot Flash Type: AMD 29F040, Size: 8 * 65536 = 524288
Compressed Pri Code size = 3265004, Version 07.5.04T53 (H2R07504.bin)
Compressed Sec Code size = 3620593, Version 07.1.24T53 (H2R07206.bin)
Maximum Code Image Size Supported: 3866112 (0x003afe00)
Boot Image size = 149436, Version 07.02.99 (bootrom.bin)
The boot code version is shown in bold type.
This command actually is showing the files installed on the management module's flash memory. However, since
the boot code must be stored on the flash module, the boot code version listed here is also the version that the
device booted with.

Determining the Image Versions Installed in Flash Memory

Enter the show flash command to display the boot and flash images installed on the management module. An
example of the command's output is shown in "Determining the Boot Image Version Running on the Device".
• The "Compressed Pri Code size" line lists the flash code version installed in the primary flash area.
• The "Compressed Sec Code size" line lists the flash code version installed in the secondary flash area.
• The "Boot Image size" line lists the boot code version installed in flash memory. The device does not have
separate primary and secondary flash areas for the boot image. The flash memory module contains only one
boot image.

Image File Types

The following table lists the boot and flash image file types supported on each HP device. For information about a
specific version of code, see the release notes.
Product
HP 9315M
HP 9308M
HP 9304M
14 - 2
Boot Image
EP module:
• M2Bxxxxx.bin (all flash images)
Standard M4 module:
• M2Bxxxxx.bin
T-Flow module:
• M2Bxxxxx.bin (all MP images)
• VSB07100.bin
Flash Image
EP module or Standard M2 or M4 module:
• H2Rxxxxx.bin (Routing Switch code)
T-Flow module:
• TSPxxxxx.bin (TSP code)