HP ProCurve 9304M Installation And Configuration Manual page 88

Installation and Basic Configuration Guide
Specify the slot number containing the currently active management module. Do not specify the slot number
containing the standby module to which you want to switch over.
The <slot-num> parameter specifies the chassis slot:
• Slots in a 4-slot chassis are numbered 1 – 4, from top to bottom.
• Slots in an 8-slot chassis are numbered 1 – 8, from left to right.
• Slots in a 15-slot chassis are numbered 1 – 15, from left to right.
USING THE WEB MANAGEMENT INTERFACE
1. Log on to the device using a valid user name and password for read-write access. The System configuration
dialog is displayed.
2. Select the Redundant link to display the following panel.
3. Select the Switch-over Active Module link. A message appears asking you to verify that you want to switch
over from the active module to the standby.
4. Select Yes to switch over or No to cancel the switchover request.
5. Click the Add button to save the change to the device's running-config file.
6. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
3 - 16