Diagnostic Error Codes And Remedies For Tftp Transfers - HP ProCurve 9304M Installation And Configuration Manual

Installation and Basic Configuration Guide

Diagnostic Error Codes and Remedies for TFTP Transfers

If an error occurs with a TFTP transfer to or from an HP Routing Switch, one of the following error codes is
displayed.
Error Message
code
1 Flash read preparation failed.
2 Flash read failed.
3 Flash write preparation failed.
4 Flash write failed.
5 TFTP session timeout.
6 TFTP out of buffer space.
7 TFTP busy, only one TFTP session can be
active.
8 File type check failed.
16 TFTP remote - general error.
17 TFTP remote - no such file.
18 TFTP remote - access violation.
19 TFTP remote - disk full.
20 TFTP remote ­ illegal operation.
21 TFTP remote - unknown transfer ID.
22 TFTP remote - file already exists.
23 TFTP remote - no such user.
14 - 20
Explanation and action
A flash error occurred during the
download.
Retry the download. If it fails again,
contact customer support.
TFTP failed because of a time out.
Check IP connectivity and make sure the
TFTP server is running.
The file is larger than the amount of room
on the device or TFTP server.
If you are copying an image file to flash,
first copy the other image to your TFTP
server, then delete it from flash. (Use the
erase flash... CLI command at the
Privileged EXEC level to erase the image
in the flash.)
If you are copying a configuration file to
flash, edit the file to remove unneeded
information, then try again.
Another TFTP transfer is active on another
CLI session or Web management session.
Wait, then retry the transfer.
You accidentally attempted to copy the
incorrect image code into the system.
Retry the transfer using the correct image.
The TFTP configuration has an error. The
specific error message describes the
error.
Correct the error, then retry the transfer.