Displaying And Modifying System Parameter Default Settings - HP ProCurve 9304M Installation And Configuration Manual

Installation and Basic Configuration Guide
Syntax: router appletalk | bgp | dvmrp | ipx | ospf | pim | rip | vrrp | vrrpe
USING THE WEB MANAGEMENT INTERFACE
To enable protocols on a Routing Switch:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Select the Enable option next to the protocol(s) to be enabled.
NOTE: If you are enabling BGP4, you must also specify the local AS number in the Local AS field.
3. Click Apply to save the changes to the device's running-config file.
4. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the configuration change
to the startup-config file on the device's flash memory.
NOTE: You also can access the dialog for saving configuration changes by clicking on Command in the tree
view, then clicking on Save to Flash.
If you enable PIM, DVMRP, RIP, or IPX, you must reload the software to place the change into effect.
1. Click on the plus sign next to Command in the tree view to list the command options.
2. Select the Reload link and select Yes when the Web management interface asks you whether you really want
to reload the software.

Displaying and Modifying System Parameter Default Settings

HP devices have default table sizes for the following parameters. The table sizes determine the maximum
number of entries the tables can hold. You can adjust individual table sizes to accommodate your configuration
needs.
• MAC address entries
• Layer 2 Port VLANs supported on a system
• Layer 3 Protocol VLANs supported on a system
• Layer 4 sessions supported
• IP cache size
• ARP entries
• IP routes
• IP route filters
• IP sub-nets per port and per device
• Static routes
• I GMP
• DVMRP routes
• IPX/SAP entries
• IPX/RIP entries
• IPX/SAP filters
• IPX/RIP filters
• IPX forwarding filters
• AppleTalk routes
6 - 44