HP ProCurve 9304M Installation And Configuration Manual page 100
Routing switches
Hide thumbs
Also See for ProCurve 9304M:
- Management and configuration manual (690 pages) ,
- Installation and getting started manual (348 pages) ,
- User manual (236 pages)
Table of Contents
Advertisement
Installation and Basic Configuration Guide
USING THE CLI
To display general information for a T-Flow, enter the following command at any CLI level:
HP9308#show vm-state
==================================================
T-FLOW MODULE (1) App CPU
CPU 1 in state of T-FLOW_STATE_RUNNING
CPU 2 in state of T-FLOW_STATE_RUNNING
CPU 3 in state of T-FLOW_STATE_RUNNING
---------------
Module 1 App CPU 1, SW: Version 07.6.04T72
Compiled on Jun 27 2003 at 21:20:01 labeled as TSP07604
DRAM 268M, BRAM 262K, FPGA Version 0050
Code Flash 4M: Primary (1676166 bytes, 07.6.04T72),
Boot Flash 131K, Boot Version 07.01.00
The system uptime is 0 day 0 hour 12 minute 21 second
General Status: 0 ipc msg rec, 2 ipc msg sent
---------------
Module 1 App CPU 2, SW: Version 07.6.04T72
Compiled on Jun 27 2003 at 21:20:01 labeled as TSP07604
DRAM 268M, BRAM 262K, FPGA Version 0050
Code Flash 4M: Primary (1676166 bytes, 07.6.04T72),
Boot Flash 131K, Boot Version 07.01.00
The system uptime is 0 day 0 hour 12 minute 21 second
General Status: 0 ipc msg rec, 2 ipc msg sent
---------------
Module 1 App CPU 3, SW: Version 07.6.04T72
Compiled on Jun 27 2003 at 21:20:01 labeled as TSP07604
DRAM 268M, BRAM 262K, FPGA Version 0050
Code Flash 4M: Primary (1676166 bytes, 07.6.04T72),
Boot Flash 131K, Boot Version 07.01.00
The system uptime is 0 day 0 hour 12 minute 21 second
General Status: 0 ipc msg rec, 2 ipc msg sent
Syntax: show vm-state
This command displays the state of the T-Flow, the software version running on the module, and detailed
information for each TSP on the module.
USING THE WEB MANAGEMENT INTERFACE
You cannot display general T-Flow information using the Web management interface.
Determining Module Status
You can determine the status of a T-Flow in the following ways:
•
Status LEDs – Each TSP has LEDs that show send and receive activity for the processor. The MP has LEDs
for data activity (both send and receive) and power.
•
Module information in software – The module information displayed by the software indicates whether the
module came up properly.
4 - 12
0 MB SHM, 3 Application Processors
Secondary (1217531 bytes, 07.3.03aT72)
Secondary (1217531 bytes, 07.3.03aT72)
Secondary (1217531 bytes, 07.3.03aT72)
Advertisement
Chapters
Table of Contents
Troubleshooting
