Enabling Or Disabling Routing Protocols - HP ProCurve 9304M Installation And Configuration Manual

Syntax: lock-address ethernet <portnum> [addr-count <num>]
USING THE WEB MANAGEMENT INTERFACE
To enable address locking on a port:
1. Log on to the device using a valid user name and password for read-write access. The System configuration
panel is displayed.
2. Click on the plus sign next to Configure in the tree view to display the configuration options.
3. Click on the plus sign next to Port in the tree view to display the configuration options.
4. Select the link to the port type you want (for example, Ethernet) to display the Port table.
5. Click on the Modify button next to the row of information for the port you want to reconfigure.
6. Select Enable next to Lock Address.
7. Enter the maximum number of MAC addresses you want the device to learn on the port in the MAC Address
field.
8. Click Apply to save the changes to the device's running-config file.
9. Select the Save link at the bottom of the dialog. Select Yes when prompted to save the confi
to the startup-config file on the device's flash memory.

Enabling or Disabling Routing Protocols

HP Routing Switches support the following protocols:
• A ppleTalk
• B GP4
• D VMRP
• I P
• I PX
• OSPF
• P IM
• R IP
• VRRP
• VRRPE
By default, IP routing is enabled on Routing Switches. All other protocols are disabled, so you must enable them
to configure and use them.
NOTE: The following protocols require a system reset before the protocol will be active on the system: PIM,
DVMRP, RIP, and IPX. To reset a system, select the Reload link (Web) or enter the reload command at the
privileged level of the CLI.
USING THE CLI
To enable a protocol on an HP Routing Switch, enter router at the global CONFIG level, followed by the protocol
to be enabled. The following example shows how to enable OSPF:
HP9300(config)# router ospf
HP9300(config)# end
HP9300# write memory
HP9300# reload
Configuring Basic Features
guration change
6 - 43