Reloading After A Specific Amount Of Time; Canceling A Scheduled Reload - HP ProCurve 9304M Installation And Configuration Manual

Updating Software Images and Configuration Files

Reloading after a Specific Amount of Time

To schedule a system reload to occur after a specific amount of time has passed on the system clock, use one of
the following methods.
USING THE CLI
To schedule a system reload from the secondary flash one day and 12 hours later, enter the following command at
the global CONFIG level of the CLI:
HP9300# reload after 01:12:00 secondary
Syntax: reload after <dd:hh:mm> [primary | secondary]
<dd:hh:mm> is the number of days, hours, and minutes.
primary | secondary specifies whether the reload is to occur from the primary code flash module or the
secondary code flash module.
USING THE WEB MANAGEMENT INTERFACE
You cannot schedule a system reload using the Web management interface.
Displaying the Amount of Time Remaining Before a Scheduled Reload
To display how much time is remaining before a scheduled system reload takes place, use one of the following
methods.
USING THE CLI
To display how much time is remaining before a scheduled system reload, enter the following command from any
level of the CLI:
HP9300# show reload
USING THE WEB MANAGEMENT INTERFACE
You cannot display information about a scheduled reload using the Web management interface.

Canceling a Scheduled Reload

To cancel a scheduled reload, use one of the following methods.
USING THE CLI
To cancel a scheduled system reload using the CLI, enter the following command at the global CONFIG level:
HP9300# reload cancel
USING THE WEB MANAGEMENT INTERFACE
You cannot cancel a scheduled reload using the Web management interface.
14 - 19