Shutting Down An Aggregate Interface; Restoring The Default Settings For An Aggregate Interface - HP 3600 v2 series Configuration Manual

CAUTION:
If you set this minimum threshold for a static aggregation group, you must also make the same setting for
•
its peer aggregation group to guarantee correct aggregation.
• Configuring the minimum number of Selected ports required to bring up an aggregation group might
cause all the member ports in the aggregation group to become unselected.

Shutting down an aggregate interface

Shutting down or bringing up an aggregate interface affects the aggregation state and link state of ports
in the corresponding aggregation group in the following ways:
• When an aggregate interface is shut down, all Selected ports in the corresponding aggregation
group become unselected and their link state becomes down.
When an aggregate interface is brought up, the aggregation state of ports in the corresponding
•
aggregation group is recalculated and their link state becomes up.
Follow these steps to shut down an aggregate interface:
To do...
Enter system view
Enter
aggregate
interface
view
Shut down the aggregate interface

Restoring the default settings for an aggregate interface

Follow these steps to restore the default settings for an aggregate interface:
To do...
Enter system view
Enter
aggregate
interface
view
Restore the default settings for the
aggregate interface
Use the command...
system-view
Enter Layer 2
interface bridge-aggregation
aggregate interface
interface-number
view
Enter Layer 3
interface route-aggregation
aggregate interface
interface-number
view
shutdown
Enter Layer 2 aggregate
interface view
Enter Layer 3 aggregate
interface view
Use the command...
system-view
interface bridge-aggregation
interface-number
interface route-aggregation
interface-number
default
44
Remarks
—
Required
Use either command.
Required
By default, aggregate interfaces
are up.
Remarks
—
Required
Use either command.
Required