Mounting A Faxfinder Expansion Module On A Wall; Mounting Faxfinder In A Rack - Multitech FaxFinder FF240 Administrator's Manual

HARDWARE AND INSTALLATION

Mounting a FaxFinder Expansion Module on a Wall

Images below show the dimensions for both the 8-port and 16-port FaxFinder Expansion Modules. To mount an
Expansion Module on a wall, follow the steps for wall mounting a Fax Server.

Mounting FaxFinder in a Rack

Rack Safety
When installing the unit in a closed or multi-unit enclosure, follow the recommended installation defined by the
enclosure manufacturer.
Note: The ambient temperature of the rack interior must not exceed 40° Celsius.
■
Do not place the unit directly on top of other equipment or place other equipment directly on top of the
unit.
■ If installing the unit in a closed or multi-unit enclosure, ensure adequate airflow within the rack so that the
maximum recommended ambient temperature (40° C) is not exceeded.
■
Ensure that the unit is properly connected to earth ground by verifying that it is reliably grounded when
mounted within a rack.
■ If a power strip is used, ensure that the power strip provides adequate grounding of the attached
apparatus.
■
When mounting the equipment in the rack, make sure mechanical loading is even to avoid a hazardous
condition. The rack should safely support the combined weight of all the equipment it supports.
■ Ensure that the main supply circuit is capable of handling the load of the equipment. See the power label on
the equipment for load requirements.
■
Only properly qualified service personnel should install this equipment. Only connect like circuits - connect
SELV (Secondary Extra Low Voltage) circuits to SELV circuits and TN (Telecommunications Network) circuits
to TN circuits.
22
Dimensions with brackets attached for wall mounting (top view)
Dimensions with brackets attached for wall mounting (front view)
®
FaxFinder Fax Server FF240, FF440, FF840 Administrator Guide