Table of Contents
Advertisement
PH Gas Logs
The positioning of the logs are critical to the safe and clean operation of this heater. Sooting and
other problems may result if the logs are not properly and fi rmly positioned in the appliance.
Never add additional logs or embellishments such as pine cones, vermiculite or rock wool to
the heater. Only use the logs supplied with the unit.
Failure to position the parts in accordance with diagrams below or to use only parts specifi cally
approved for this heater may result in property damage or personal injury.
PLACE PH24-R LOGS
1. Place Rear Log (#1) on rear support. Figure 20
2. Place Left Middle Log (#2) on middle support and
burner. Figure 21
3. Place Right Middle Log (#3) on middle support.
Figure 21
NOTE: Logs #1, #2 and #3 have ridges on the bottom
which secure the logs to burner frame. After installing
each log, check to be sure it is stable.
Left Middle Log #2
Figure 21
18
Figure 20
Right Middle Log #3
Rear Log #1
D O N O T s p r i n k l e
volcanic rock on the
logs or around the pilot
or the main burner. This
may cause sooting.
Only place volcanic
rock on the fl oor of the
fi replace.
During initial operation
o f t h e n e w h e a t e r,
burning logs will give off
a paper burning smell
and orange fl ames will
be present. Simply open
the windows for a few
hours to vent the odor.
LG1089
LOG PLACEMENT
LG1088
65D2035
Advertisement
Table of Contents
