Adjustment
11.
Thread catcher reverse position
05.13
(On Model 1246 make these adjustments on both thread catchers.)
11 - 32
Requirement
At the front point of reversal of thread catcher 3, its rear edge must be flush with the
cutting edge of knife 4 (see arrow).
4
2
Fig. 11 - 28
Taking care to ensure that screw 1 is loosened, bring the machine to needle rise
position and activate the engaging lever.
By continuing to turn the handwheel, bring rock shaft 2 to its left point of reversal.
Maintaining this position, turn thread catcher 3 in accordance with the
requirement.
3
4
3
1