Adjustment
11.
Lifting motion of the top feed
04.10
11 - 12
Requirement
When presser foot 1 is resting on the needle plate, the vibrating presser foot 4 and the
point of the needle must both reach the needle plate at the same time when the top feed
stroke is set at maximum.
1
4
Fig. 11 - 10
Allow presser foot 1 to rest on the needle plate.
Loosen screws 2 until feed lifting eccentric 3 can be turned on its shaft with difficulty.
Turn feed lifting eccentric 3 in accordance with the requirement.
Tighten screws 2.
Carry out a check in accordance with the requirement.
2
3