Adjustment
1
Position of the thread catcher holder
.07 .02
● Adjust the thread catcher holder 1 (screws 2) according to the requirements.
42
Requirement
1. There should be a minimum amount of play between toothed wheel 3 and toothed
segment 4.
2. Both in the neutral position and the foremost position of the catcher, the distance
between the toothed segment 4 and the outer edge of the thread catcher holder 1
should be the same (see arrow).
Fig. 1 - 33
If requirement 2 cannot be fulfi lled, loosen screw 2 and move the toothed
segment 4 by one tooth.
1
4
3
1
2
4
1
4
2