Mounting And Commissioning The Machine; Mounting; Adjusting The Table-Top Height - Pfaff 1245 Instruction Manual

8

Mounting and commissioning the machine

8.

Mounting

01
The necessary electricity and compressed air supplies must be available at the machine's
location (see specifications).
A stable and horizontal surface as well as sufficient illumination at the machine's location.
8

Adjusting the table-top height

.01.01
Fig. 8 - 01
Loosen screws 1 and 2.
Set the desired table-top height and tighten screws 1 well.
Adjust the position of the right pedal so that you can operate it comfortably and tighten
screw 2.
The setting of the left pedal can be adjusted with chain 3. (This adjustment is not
necessary on machines with an automatic presser-foot lifter)
Mounting and commissioning the machine
The machine must only be mounted and commissioned by qualified personnel!
All relevant safety regulations are to be observed!
If the machine is delivered without a table, it must be ensured that the frame
and the table top which you intend to use can hold the weight of the machine
and the motor, even while sewing.
Due to reasons of packaging, the table top is lowered for transport. The
following is a description of how to adjust the height of the table top.
1
3
2
1
8 - 1