Adjustment
11.
Linkage rod
05.07
11 - 26
Requirement
When shaft 9 begins its sliding motion, lever 6 must simultaneously lift from stop 7.
4
6 7
5
Fig. 11 - 23
Affix spherical head 1 to control lever 3 using screw 2.
Loosen nuts 4 (right and left handed thread).
Bring the machine to needle rise position by turning the handwheel and activate
engaging lever 5.
Taking care to ensure that lever 6 is touching stop 7 (see arrow), turn linkage rod 8 in
accordance with the requirement.
In this position tighten both nuts 4.
Carry out a check in accordance with the requirement.
2
1
8
9
3