Checking The Nxt-Bp Battery Charge; Installing The Nxa-Base/B To An Nxt Modero Panel - AMX NXD-1700VG Instruction Manual

NXA-BASE/B Specif ications (Cont.)
Operating / Storage
Environment:
Other AMX Equipment:
NOTE: It is recommended to fully charge the batteries before their initial use.

Checking the NXT-BP Battery Charge

1. Press the Battery Life Indicator button (FIG. 27) once to illuminate the Battery Life LEDs and display the percent charge
remaining on the battery (this indication lasts a few seconds).
NXT-BP (showing Battery Life Indicator button and charge)
FIG. 27
2. Repeat the above step for each NXT-BP battery.
3. Charge the NXT-BP battery by either inserting it into the battery base or from within the optional NXT-CHG charger (which can
sequentially charge up to two batteries).
NOTE: If the 25% LED is blinking, this indicates there is less than 5% of a charge remaining on the battery.

Installing the NXA-BASE/B to an NXT Modero Panel

The battery base must be installed onto the NXT panel without any NXT-BP batteries.
1. Power Off the panel before attempting to use the NXA-BASE/B.
2. Place the empty battery base onto a flat/level surface.
3. Verify the alignment of the Panel Interface connectors between the panel (male connector) and base (female connector)
(FIG. 28).
Battery Compartment
pulls outwards
Alignment
pegs
NXA-BASE/B showing Panel Interface and connector locations
FIG. 28
4. Carefully place the Modero panel over the base alignment pegs (FIG. 28 and FIG. 29).
NOTE: The battery base cannot be "hot-swapped". A panel receiving power through a connected 12 VDC-compliant power
supply cannot have a battery base installed onto the bottom of the panel while powered. POWER OFF the panel before installing
the NXA-BASE/B. "Hot swapping" could damage the base and cause it not to be recognized by the panel.
5. Gently apply downward pressure until the panel is securely mounted to the battery base (FIG. 29).
Modero VG Series Touch Panels - Instruction Manual
• Operating Temperature: 0° C (32° F) to 40° C (104° F)
• Operating Humidity: 20% - 85% RH
• Storage Temperature: -20° C (-4° F) to 60° C (140° F)
• Storage Humidity: 5% - 85% RH
• NXT-CHG Kit (FG2250-50K):
1 charger (FG2250-50) and 2 NXT-BP batteries (FG2255-10)
• NXT-BP battery pack (FG2255-10)
• NXT-CHG battery charger (FG2250-50)
Battery Life (Charge) Display
Battery Life Indicator button
Captive fasteners
(secure base to
panel)
Panel Interface
connector (female)
Touch Panel Accessories
40