Security Settings - AMX NXD-1700VG Instruction Manual

Protected Setup Page Elements (Cont.)
System Recovery:
Channel Port
Level Port
Channel Code
Number
Button/slider Function Show example
FIG. 116

Security Settings

The Security button on the Protected Setup page has three settings: Standard Security, Secure, and DoD. Each setting has different
features for touch panel security:
Security Prof ile Features
Standard Security:
Secure:
DOD:
Toggling between these three immediately and automatically resets the existing password to the default password for that setting.
With an unsecured panel using the Standard Security setting, the default password is 1988. With panels using either the Secure or
the DoD settings, the default password is Amx1234! (paying attention to the case of the letters). Entering the existing password will
not work and the default will need to be entered at this point will allow access to the Protected Settings page and allow resetting of
the password to a new one.
Modero VG Series Touch Panels - Instruction Manual
Allows you to either reset the touch panel to factory default settings and/or wipe out all existing touch
panel pages:
• The Reset System Settings button allows a user to wipe out all current configuration parameters on
the touch panel (such as IP Addresses, Device Number assignments, Passwords, and other presets).
- Pressing this button launches a Confirmation dialog that asks you to confirm your selection.
- This dialog is configured with a delay timer that does not enable the YES button for 5 seconds. This
delay provides an additional amount of time for the user to confirm their decision.
• The Remove User Pages button allows you remove all current TPD4 touch panel pages currently on the
panel (including the pre-installed AMX Demo pages).
- Pressing this button launches a Confirmation dialog which asks you to confirm your selection.
- This dialog is configured with a delay timer that does not enable the YES button for 5 seconds. This
delay provides an additional amount of time for the user to confirm their decision.
Channel Code
Number
3,132 Address
Port
Button
2,8 3,50
Address Code
Number
• Factory default, shipped in this configuration.
• Administrator and NetLinx user accounts have a default password of "password".
• Telnet, HTTP, HTTPS, and SSH are all enabled and require no authentication.
• Program terminal requires no authentication.
• ICSP communication protocol between devices: encryption and authentication are disabled.
• FTP is enabled.
• Minimum password requirement is 4 characters.
• Must be configured from the program terminal.
• HTTP, Telnet, and FTP are disabled.
• SSH, HTTPS, and program terminal require authentication by an authorized user.
• SSH, HTTPS, and program terminal session timeouts are enabled.
• ICSP communication protocol between devices: encryption and authentication are enabled.
• Minimum password requirement is 8 characters with at least 1 numeric character.
• Login failure attempt pauses 4 seconds before another login attempt is allowed.
• After 3 consecutive unsuccessful login attempts, login lockout is enabled for 15 minutes.
• Login and logout audit logging is enabled.
• Must be configured from the program terminal.
• HTTP, Telnet, and FTP are disabled.
• SSH, HTTPS, and program terminal require authentication by an authorized user.
• SSH, HTTPS, and program terminal session timeouts are enabled.
• ICSP communication protocol between devices: encryption and authentication are enabled.
• Minimum password requirement is 8 characters with at least 1 numeric character, one uppercase character, one
lowercase character, and one special character, with no duplicate adjacent characters.
• Login failure attempt pauses 4 seconds before another login attempt is allowed.
• After 3 consecutive unsuccessful login attempts, login lockout is enabled for 15 minutes.
• Login and logout audit logging is enabled.
• DoD session banner is enabled.
Channel Port
7,10
Slider
Level Port
4,9
1,8
Channel Code
Number
Firmware Pages and Descriptions
Channel Code
Number
Address
Port
Address Code
Number
118