Checking The Nxt-Bp Battery Charge; Installing The Nxa-Base/B To An Nxt Modero Panel - AMX Modero NXT-1500VG Operation/Reference Manual

Touch Panel Accessories

Checking the NXT-BP battery charge

1. Press the Battery Life Indicator button (FIG. 27) once to illuminate the Battery Life LEDs and
display the percent charge remaining on the battery (this indication lasts a few seconds).
FIG. 27 NXT-BP (showing Battery Life Indicator button and charge)
2. Repeat the above step for each NXT-BP battery.
3. Charge the NXT-BP battery by either inserting it into the battery base or from within the optional
NXT-CHG charger (which can sequentially charge up to two batteries).
If the 25% LED is blinking, this indicates there is less than 5% of a charge remaining
on the battery.

Installing the NXA-BASE/B to an NXT Modero Panel

The battery base must be installed onto the NXT panel without any NXT-BP batteries.
1. Power Off the panel before attempting to use the NXA-BASE/B.
2. Place the empty battery base onto a flat/level surface.
3. Verify the alignment of the Panel Interface connectors between the panel (male connector) and base
(female connector) (FIG. 28).
Battery Compartment
pulls outwards
Alignment
pegs
FIG. 28 NXA-BASE/B showing Panel Interface and connector locations
4. Carefully place the Modero panel over the base alignment pegs (FIG. 28 and FIG. 29).
46
Battery Life (Charge) Display
Battery Life Indicator button
Captive fasteners
(secure base to
panel)
Panel Interface
connector (female)
VG-Series Modero Touch Panels