Upgrading Nxa-Rgb And Nxa-Avb/Rgb Firmware - AMX NXD-1700VG Instruction Manual
Modero vg series wall/flush mount touch panels
Hide thumbs
Also See for NXD-1700VG:
- Datasheet (3 pages) ,
- Quick start manual (2 pages) ,
- Dimension manual (1 page)
Table of Contents
Advertisement
Upgrading NXA-RGB and NXA-AVB/RGB Firmware
1.
Identify the Device number of the target panel being used for firmware routing to the accessories.
2.
Complete the instructions for configuring the NetLinx Master for IP communication found in the Step 1: Prepare the Master for
communication via an IP section on page 95.
3.
Press the grey Front Setup Access button for 3 seconds to open the Setup page.
4.
Press the Video Adjustment > RGB Adjustment buttons to open the RGB Adjustment page (FIG. 99). This page displays the
firmware for both the internal NXA-RGB card and the communicating external NXA-AVB/RGB Breakout Box (BOB).
RGB Adjustment page (showing the default values)
FIG. 99
5.
Follow the procedures outlined within the Step 2: Upgrade the NXA-BASE/B f irmware via an IP section on page 98.
NOTE: If f irmware is updated to either the panel or the breakout box, both units must be power-cycled for the panel to detect and
display the new BOB f irmware version.
Modero VG Series Touch Panels - Instruction Manual
Firmware version of the NXA-RGB card
Firmware version of the NXA-AVB/RGB
Incoming signal shown in the background
Upgrading Modero Firmware
100
Advertisement
Table of Contents
