Upgrading The Nxa-Rgb And Nxa-Avb/Rgb Firmware - AMX NXD-1200VG Operation/Reference Manual

Upgrading Modero Firmware
FIG. 98 Send to NetLinx Device dialog (showing NXA-BASE/B firmware update via IP)
7.
Select the battery base's KIT file (ending in VXX.kit) from the Files section (FIG. 98).
8.
Enter the Device value associated with the panel and the System number associated with the Master (listed in the
OnLine Tree tab of the Workspace window). The Port field is greyed-out.
The firmware for the battery base can not be downloaded directly. Download of the
KIT file to the BASE/B is done through the panel. The procedures for updating
firmware to the base are nearly identical to those for updating panel firmware, except
that the KIT file selected must be that of the BASE/B.
9.
Click the Reboot Device checkbox. This causes the touch panel to reboot after the firmware update process is
complete. The reboot of the panel can take up 30 seconds after the firmware process has finished.
10.
Click Send to begin the transfer. The file transfer progress is indicated on the bottom-right of the dialog (FIG. 98).
11.
Click Close on the Send to NetLinx dialog window (after the panel reboots) to return to the main program.
12.
Right-click the associated System number and select Refresh System. This causes a refresh of all project systems,
establishes a new connection to the Master, and populates the System list with devices on your particular system.
13.
Press and hold the grey Front Setup Access button (below the LCD) for 3 seconds to access the Setup page.
14.
Press the Battery Base button to open the Battery Base page and confirm that the version is no longer 0.00.
If the Base Version field displays 0.00, this means there was an error in the firmware
download process. Re-install the base firmware and re-confirm that the new base
version no longer reads 0.00.

Upgrading the NXA-RGB and NXA-AVB/RGB Firmware

1.
Identify the Device number of the target panel being used for firmware routing to the accessories.
2.
Complete the instructions for configuring the NetLinx Master for IP communication found in the Step 1: Prepare
the Master for communication via an IP section on page 107.
3.
Press the grey Front Setup Access button for 3 seconds to open the Setup page.
4.
Press the Video Adjustment > RGB Adjustment buttons to open the RGB Adjustment page (FIG. 99). This page
displays the firmware for both the internal NXA-RGB card and the communicating external NXA-AVB/RGB
Breakout Box (BOB).
112
Selected Battery Base Firmware file
Description field for selected
Firmware download
status
Device value and System number
must match the values
listed in the Workspace window
VG Series Modero Touch Panels