Op-01614, Op-01664 Supply Break - DataCard SP75 Manual

OP-01614, OP-01664 Supply Break

The supply material is broken in the laminator.
Possible Cause 1: The supply material is broken.
Solution 1: Fix the supply material:
1 Remove the laminator cartridge.
2 Trim the broken supply material evenly.
3 Fasten the cut end of the supply material to the supply material on the
take-up spool.
4 Replace the laminator cartridge in the printer.
Possible Cause 2: The supply material is stuck to the card.
Solution 2a: Turn the Laminator Advance Knob to move the card (A) and
separate it from the supply material. You can turn the knob in both
directions.
Solution 2b: It it is difficult to turn the Laminator Advance Knob or you hear
clicks when you turn it, remove the laminator cartridge (B). Pull firmly to
remove the cartridge.
Tips for success
• If a card is also stuck in the printer, make sure the card can move freely
before clicking the Retry button or pushing the Ready key.
If you cannot fix the problem, contact your service provider for assistance.
Page 93