Sy-01332 Hardware Error - DataCard SP75 Manual

SY-01332 Hardware Error

General printer fault.
Possible Cause 1: The printhead cable is not attached to the printhead
cartridge.
Solution 1: Power off the printer. Make sure the printhead cable is fully
seated in the printhead cartridge. Close the printer and power it on.
Possible Cause 2: The printer identified a problem while it was running a
diagnostic test.
Solution 2: Power the printer off and on.
If you cannot fix the problem, contact your service provider for assistance.
See SP Series Info Central for details about connecting the printhead if
needed.
Page 69