Lightbulb: Removal & Replacement; General Maintenance - Dirt Devil M140000 Owner's Manual

LIGHTBULB: REMOVAL & REPLACEMENT*
TOOL REQUIRED: FLATHEAD AND PHILLIPS SCREWDRIVER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK - UNPLUG CLEANER BEFORE REMOVING OR
REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For bulb replacement call 1-800-321-1134
or visit your local auto parts store.
2.
1.
Lean cleaner handle Using the end of a
back. Remove the one Flathead screwdriver,
(1) screw. gently pop open the
lens. Remove lens.
* In Select Models Only

GENERAL MAINTENANCE

WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
DEBRIS REMOVAL/ DEBRIS REMOVAL/
HOSE NOZZLE GUARD
1. 2. 3.
DEBRIS REMOVAL/AIR POWERED HAND TOOL*
3. 4.
O RING
Turn the Air Powered Hand Pivot lower housing and
Tool* over and slide off the remove clog.
O-ring.
* In Select Models Only
3.
4.
Pull bulb out of socket. Snap lens back into
Do NOT twist. Gently place (Diagram
push bulb into socket Secure the headlight
to replace. lens by replacing the
one screw (Diagram 4a).
1. Check to see if dirt container is full; empty if
needed.
2. Plug cleaner in and check to see if there is any
suction at end of hose. If there is suction at
end of hose, move on to Diagram 4. If there
is no suction at the end of hose, follow these
steps: 1. Unwrap hose from caddy. Remove
obstruction. Check hose curve (near dust brush)
and remove obstruction (Diagram 1). 2. Remove
dirt container (Pg. 9) and check dirt container
inlet located on cleaner (Diagram 2).
3. Remove nozzle guard (see Diagram 3) by
removing the three (3) screws. Remove
obstruction.
5.
To reassemble, be sure tabs are engaged. Pivot
the lower housing closed. Slip the O-ring into the
groove at the neck of the Air Powered Hand Tool*
to complete reassembly.
11
4a.
4)