Belt Or Brush Roll Removal And Replacement; Lightbulb Removal And Replacement; How To Transport Cleaner; Belt Storage - Dirt Devil Upright vacuum Owner's Manual

BELT OR BRUSH REMOVAL & REPLACEMENT
TOOL REQUIRED: PHILLIPS SCREWDRIVER
I
BELT STYLE:
4
&
5
1
WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS
-
UNPLUG CLEANER BEFORE CHANGING BELT OR BRUSH ROLL.
TO REMOVE BELT
Flip cleaner to expose nozzle base as shown in (Diagram 1). To remove nozzle cover, use Phillips screwdriver to
remove the four screws. Arrows in diagram 1 show location of screws. Flip cleaner back over and lift nozzle cover off. Slide belt off motor
shaft (Diagram 2). Lift and remove brush roll (Diagram 3). Dispose of old belt.
TO REPLACE BELT
1. Place belt on motor shaft, then slip brush roll through belt. Place belt in area of brush roll without bristles (Diagram 4).
2. With belt in place, pull and slide brush roll into nozzle (Diagram 3) making sure that the brush roll end caps are in the correct orientation
(Diagram 3a inset).
IMPORTANT: Rotate brush roll manually to make sure belt is not twisted or pinched.
3. Reattach nozzle cover. Secure by replacing the screws under the nozzle base.
BELT STORAGE
See page 4. (Fig. 4)
-
stretch belt around hooks. (Fig. 5)
-
fold and secure belt (in a u shape) on the inside of the loops on the back of the
upright.
LIGHTBULB* REMOVAL & REPLACEMENT
TOOL REQUIRED: FLATHEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK
-
UNPLUG CLEANER BEFORE REMOVING OR REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For bulb replacement call 1-800-321-1 134 or your local auto parts store.
1. Remove front panel (See page 9, Diagram 1). Lean cleaner handle back. Insert end of standard screwdriver into the side slot and pry
outward to pop headlight lens out.
2. Pull bulb out of socket to remove. Push bulb into socket to replace (Diagram 2).
3. Snap headlight lens panel back into place. Reattach front panel.
HOW TO TRANSPORT CLEANER
Use the carrying handle on the back of the cleaner to move cleaner from room to room (Diagram 3).
NOTE: Do not push cleaner forward while leaning on back casters, pull cleaner on back casters, or attempt to lift cleaner using upper handle.
N o t available on all models.