Lightbulb: Removal & Replacement; General Maintenance - Dirt Devil vacuum cleaner Owner's Manual

LIGHTBULB: REMOVAL & REPLACEMENT
TOOL REQUIRED: SMALL PHILLIPS HEAD SCREWDRIVER
WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK - UNPLUG CLEANER BEFORE REMOVING OR
REPLACING LIGHTBULB.
This cleaner uses a common automotive lamp #906, 13.0 volts. For bulb replacement call 1-800-321-1134
or visit our website at www.dirtdevil.com to locate a dealer nearest you.
2.
1.
Lean cleaner handle back. Remove
Pull bulb out of socket to remove.
the two (2) screws located on Do NOT twist. Gently push bulb into
either side of the headlight lens. socket to replace.

GENERAL MAINTENANCE

WARNING: TO REDUCE THE RISK OF INJURY FROM MOVING PARTS - UNPLUG BEFORE SERVICING.
DEBRIS DEBRIS REMOVAL/
REMOVAL/HOSE NOZZLE GUARD
1. 2.
3.
DEBRIS REMOVAL/POWER BRUSH TOOL
4. 5.
LOCKING RING
Rotate locking ring 180˚ and Pivot lower housing and
turn Power Brush Tool over. remove clog.
3.
Secure the headlight lens by
replacing the two (2) screws.
1. Check to see if dirt cup is full; empty if needed.
2. Plug cleaner in and check to see if there is
any suction at end of hose (Diagram 1). If
there is suction at end of hose, move on to
Diagram 3. If there is no suction at the end of
hose, clear dirt path window and lower hose.
Follow these steps: 1. Unplug cleaner. 2. Twist
and pull hose from upper hose inlet (Diagram
2). 3. Unwrap hose from caddy. Remove
obstruction.
3. Diagram 3: Remove nozzle guard (see
Diagram 1) by removing the five (5) screws.
Look for any obstructions and remove.
Remove brushroll if necessary.
6.
To reassemble, be sure tabs
are engaged and pivot the
lower housing closed.
11
TABS