System Information; Gtn Setup Page; Figure 3-10. System Information Page; Figure 3-11. Gtn 7Xx Setup Page - Garmin GTN 6 series Maintenance Manual

3.3.2

System Information

View the System Information page, as shown in Figure 3-10,
by touching System Information key on the Configuration
Mode page. The System Information page displays the unit
type, serial number, and system ID for the GTN. It also
contains the software and hardware versions of the Main, I/O,
Display, Keypad, LED, GPS/WAAS, COM and NAV boards.
This information is also available for certain other LRUs
connected to the GTN. Touch the GTN key and choose which
LRU to display. Touch UP or DOWN to view all the
information.
3.3.3

GTN Setup Page

This section provides a brief overview of the pages that are
accessed from the GTN Setup page, as shown in Figure 3-11,
are described below. To access the GTN Setup page, touch the
GTN Setup key from the Configuration Mode page as shown
in Figure 3-8.
ARINC 429
This page allows the user to configure the ARINC 429 input
and output ports on the GTN. Both ARINC 429 formats and
bus speeds are set from this configuration page.
RS-232
This page allows the user to configure the RS-232 input and
output ports on the GTN.
HSDB (Ethernet)
This page allows the user to set which Ethernet ports are
connected.
Interfaced Equipment
This page allows the user to configure which LRUs are installed and interfaced to the GTN. The
Transponder selection is automatically configured when a valid transponder configuration is selected
under the RS-232 page.
Main Indicator (Analog)
This page allows the user to calibrate the OBS resolver, and configure the CDI key, selected course for
GPS and VLOC as well as the V-Flag state.
190-01007-B1
Rev. 1
Figure 3-10. System Information

Figure 3-11. GTN 7XX Setup Page

GTN 6XX/7XX Part 27 AML STC Maintenance Manual
Page
Page 3-7