Panasonic KX-VC1300 User Manual page 158

Using Multicast
3.
Use [ ][ ] to select "Target" and press [ENTER].
•
The multicast target screen is displayed.
4.
Use [ ][ ] to select a multicast target and press [ENTER].
•
The " " mark in the selection column will be added or removed. The multicast will start for the multicast
targets displaying a " " mark.
Note
•
If no multicast targets with a " " mark displayed are registered in the selection column, the multicast
will not begin when [START] is pressed.
•
If [ ] is displayed in a target's LAN column, multicasting will not start when you press [START].
The IP address specified for "IP Address" (Page 154) is an IP address of a network that the target
cannot communicate with. Confirm the target's IP address.
5.
Press [START].
•
The multicast preparation screen is displayed, and when connection confirmations for lower-level
terminals are completed, the multicast will start.
Note
•
If [END] is pressed during multicast preparation, the multicast will be cancelled.
•
If no response is received from a lower-level terminal for a connection confirmation for
approximately 1 minute, the multicast tree will adjust and then the multicast will start.
6.
To end the multicast, press [END].
158 User Manual Document Version 2015-12