Table of Contents
Advertisement
Standard Installation Checklist
This standard installation checklist is to be used by the installer in conjunction with, not instead of, the instructions contained within this
installation manual.
Customer
Install Address:
Model (circle one): L38FSDN, L38FSDL, L38FSDNI, L38FSDLI, L42FSDN,
L42FSDL, L42FSDNI, L42FSDLI L52FSDN, L52FSDL, L52FSDNI, L52FSDLI
Appliance Install: Section 2
Framing complies with install manual.
Standoffs have been installed.
Proper clearances have been maintained.
Venting: Section 3
Venting configuration complies with vent diagrams.
Venting installed, fastened, and secured in place maintaining proper clearance.
Firestops installed.
Exterior wall/roof flashing installed and sealed in compliance with local building code.
Terminations installed and sealed in compliance with local building code.
Direct vent termination is highest point in vent assembly.
Wiring/Electrical: Section 4
Unswitched power provided to the appliance PPO box.
Low voltage wire connected to dry contact wall switch (non-powered)
Gas: Section 5
Proper appliance for fuel type.
Was a conversion performed?
Leak check performed & inlet pressure verified.
Finishing: Section 6
Only non-combustible materials installed in non-combustible areas.
Clearances meet installation manual requirements
Mantels and/or projections comply with install manual
Appliance Setup: Section 7 through 9
Media, door, and screen installed according to install manual
Manual given to home owner.
Started appliance and verified no gas leaks exist.
Comments:
XG0223
Date Installed:
Location of Fireplace:
Installer:
Dealer Phone:
Serial #:
YES
NO
General
IF NO, WHY NOT?
5
Advertisement
Table of Contents
