Draytek Vigor2920n User Manual page 266

CLIR (hide caller ID)
Call Waiting
Call Transfer
Prefer Codec
Default SIP Account
Vigor2920 Series User's Guide
Index (1-60) in Phone Book - Enter the index of phone book
profiles. Refer to section DialPlan – Phone Book for detailed
configuration.
Check this box to hide the caller ID on the display panel of the
phone set.
Check this box to invoke this function. A notice sound will
appear to tell the user new phone call is waiting for your
response. Click hook flash to pick up the waiting phone call.
Check this box to invoke this function. Click hook flash to
initiate another phone call. When the phone call connection
succeeds, hang up the phone. The other two sides can
communicate, then.
Select one of five codecs as the default for your VoIP calls. The
codec used for each call will be negotiated with the peer party
before each session, and so may not be your default choice. The
default codec is G.729A/B; it occupies little bandwidth while
maintaining good voice quality.
If your upstream speed is only 64Kbps, do not use G.711 codec.
It is better for you to have at least 256Kbps upstream if you
would like to use G.711.
Single Codec – If the box is checked, only the selected Codec
will be applied.
Packet Size-The amount of data contained in a single packet.
The default value is 20 ms, which means the data packet will
contain 20 ms voice information.
Voice Active Detector - This function can detect if the voice
on both sides is active or not. If not, the router will do
something to save the bandwidth for other using. Click On to
invoke this function; click off to close the function.
You can set SIP accounts (up to six groups) on SIP Account
page. Use the drop down list to choose one of the profile names
for the accounts as the default one for this phone setting.
Play dial tone only when account registered - Check this box
to invoke the function.
254