Load-Balance Policy - Draytek Vigor2920n User Manual

After finishing all the settings here, please click OK to activate them.
4 . 1 . 4 L o a d - B a l a n
4 . 1 . 4 L o a d - B a l a n
This router supports the function of load balancing. It can assign traffic with protocol type, IP
address for specific host, a subnet of hosts, and port range to be allocated in WAN interface.
The user can assign traffic category and force it to go to dedicate network interface based on
the following web page setup. Twenty policies of load-balance are supported by this router.
Note: Load-Balance Policy is running only when more than one WAN interface is
activated.
Index
Enable
Protocol
WAN
Src IP Start
Src IP End
Dest IP Start
Mode – Choose ARP Detect or Ping Detect for the system to
execute for WAN detection.
Ping IP – If you choose Ping Detect as detection mode, you
have to type IP address in this field for pinging.
TTL (Time to Live) – Displays value for your reference. TTL
value is set by telnet command.
c e P o l i c y
c e P o l i c y
Click the number of index to access into the load-balance policy
configuration web page.
Check this box to enable this policy.
Use the drop-down menu to change the protocol for the WAN
interface.
Use the drop-down menu to change the WAN interface.
Displays the IP address for the start of the source IP
Displays the IP address for the end of the source IP.
Displays the IP address for the start of the destination IP.
119
Vigor2920 Series User's Guide